Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 212

Creating Step Ladder Program Instructions
Converting Ladder
Diagrams to Mnemonics
3. To edit the text in the annotation, double-click the annotation. The following
diagram shows the appearance of the annotation when it can be edited.
4. Input the text. In this example, "A/M Switch" has been input. (Press the En-
ter Key to create a new line.)
5. To stop editing the annotation, click on something other than the annotation.
The annotation will contain the new text.
Note a) To change the size of the font in the annotation, select the annota-
tion, click the right mouse button to display the pop-up menu and
select Selected Annotation/Font Size. (The default font size is
12 points.)
b) If the text is not being displayed, even if the font size is changed, it
may be necessary to enlarge the annotation. Select the annota-
tion again, select the J symbol on the right side of the annotation
(arrows will be displayed on both sides of the symbol), and en-
large the annotation.
c) When the annotation is displayed over a function block or con-
necting line and covers up a symbol, select Selected Annota-
tion/Send Behind Symbols and Lines.
d) If two annotations overlap, either one can be moved to the front or
back by selecting Selected Annotation/Bring to Front or Se-
lected Annotation/Send to Back.
Take the following steps to convert the step ladder programs created in the lad-
der diagram into mnemonic code and display the program in mnemonic code.
This procedure is possible only when ITEM200 (the Mnemonic Flag) of the step
ladder program (block model 301) is set to 0. The step ladder program cannot be
converted to mnemonic code if ITEM200 is set to 1.
Section 3-7
185