Installing Finsgateway Embedded Version - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Installing and Uninstalling the Software

2-1-6 Installing FinsGateway Embedded Version

Using FinsGateway Version 3
Installation of FinsGateway Version 3
1, 2, 3...
58
lation is continued without restarting the computer, the FinsGateway will not
operate properly.
The CX-Process Tool cannot be used if it is installed alone. Either the FinsGate-
way Embedded Version or CX-Server must be installed on the same computer
as the communications driver.
The CX-Process Tool comes with FinsGateway Embedded Version 3 and 2003.
Install either version. FinsGateway Runtime Version can also be used. If the
Runtime Version has been already installed, there is no need to install the
Embedded Version.
The FinsGateway Update 3.12 software must be installed after the FinsGate-
way Embedded Version 3 software.
1. Select one of the following folders from within the Fgwv3/FGW3ee folder.
(Select the folder corresponding to the communications method being used
in the PLC.)
Folder
name
Clk Select this folder when connecting the PLC and personal computer
(the CX-Process Tool and the CX-Process Monitor) via Controller
Link using a Controller Link Support Board (ISA bus) installed in an
ISA slot in the computer.
Clk (PCI) Select this folder when connecting the PLC and personal computer
(the CX-Process Tool and the CX-Process Monitor) via Controller
Link using a Controller Link Support Board installed in the computer's
PCI slot.
Etn Select this folder to connect the personal computer (the CX-Process
Tool and the CX-Process Monitor) to the PLC via Ethernet.
Serial Select this folder to connect the personal computer (the CX-Process
Tool and the CX-Process Monitor) to the PLC via the Host Link.
The following procedure uses Host Link as an example.
Section
Details
2-1