Reset Factory Defaults; Storage Devices (Hard Disk And Ram Disk) - Xante FilmMaker 4 User Manual

2. Select Printer Configuration: Print Quality: Print Density (fig. 2.116). The Print
Density window appears (fig. 2.117).
3. Select the density level for your printer in increments of one. Then select
Change.
4. Close the browser.

Reset Factory Defaults

Reset Factory defaults allows you to reset the printer name and EtherTalk Zone, to
enable startup page and low toner page printing, to enable DHCP, and to reset
PostScript margins to factory default settings.
If you select reset to factory default, enabling DHCP could affect your IP address.
1. Go to the printer home page (fig. 2.118). See "Printer Home Page" earlier in
this chapter for details.
Fig. 2.118 Printer Home Page
2. Select Printer Configuration: Reset Factory Defaults (fig. 2.118). The Print
Reset Factory Defaults window appears (fig. 2.119).
3. Click Reset Factory Defaults. Your printer will restart and the changes will be in
effect.
Factory defaults also may be reset using the printer's front panel keys. See "Resetting
to Factory Defaults" in chapter 4 for details.

Storage Devices (Hard Disk and RAM Disk)

Storage Devices allows you to display current hard disk and RAM disk settings and
configure the device.
2-56 Macintosh Setupbb
Fig. 2.119 Reset Factory Defaults Window