Xante FilmMaker 4 User Manual page 206

1. Make sure the printer is on and idle. Then, make sure that media the size of
your final output is loaded in the printer's paper cassette and the cassette is
selected as the media source.
2. Press the Menu key until SETUP: GRAPHIC appears. Then, press the Enter
key.
3. Press the Menu key until GRAPHIC: XACT appears. Then, press the Enter key.
4. Press the Menu key until TEST PAGE appears. Then, press the Enter key. A
page prints with 2 lines, Line A and Line B. The measurement listed by each line
is the desired length for that line on that media size. In this example, Tabloid
size 11" x 17" (257 mm x 431 mm) media is used. Line A should be 251.46 mm
and Line B should 388.61 mm.
5. Measure Line A. Use the following procedures to adjust the printer for the
correct line length.
a. Note the amount Line A is over or under 251.46 mm.
b. Press the Menu key until LINE A appears. Then, press the Enter key.
c. Press the Menu key until the amount which would most closely adjust
the line to the desired length appears. Then, press the Enter key. For
example, if Line A is 250.46 mm instead of 251.46 mm, select 1.00 mm to
add one mm to make the line the correct length.
6. Measure Line B. Use the following procedures to adjust the printer for the
correct line length.
a. Note the amount Line B is over or under 388.61 mms.
b. Press the Menu key until LINE B appears. Then, press the Enter key.
c. Press the Menu key until the amount which would most closely adjust
the line to the desired length appears. Then, press the Enter key. For
example, if Line B is 389 mm instead of 388.61 mm as it should be, select
-0.50 mm to shorten the line to 388.50.
7. Press the Reset key to return to the previous menu level. Then, press the Menu
key until XACT: TEST PAGE reappears and press the Enter key to print a new
test page.
4-10 Configuration