Xante FilmMaker 4 User Manual page 252

a. Squeeze the top cover latch to release the lock and then lift the top cover
(fig. 7.9); the multipurpose feeder opens automatically as you open the
top cover. Then, open the fuser cover (fig. 7.9).
Fig. 7.9 Open Top and Fuser Covers
b. Remove the front panel's inside securing screw (fig. 7.10); then, remove
the front panel's rear securing screw (fig. 7.11); then, lift the front panel
cover up just enough to clear the printer and tilt the cover onto its left
side (fig. 7.12).
Fig. 7.11 Remove Panel's Rear Screw
c. Disconnect the display cable by gently pulling it out of its connector (fig. 7.12).
3. Press down on the front side cover's two top hooks, lift the cover slightly to
release its two bottom tabs; then, pull the cover out from the printer (fig. 7.13).
7-8 Options
Fig. 7.10 Remove Panel's Inside Screw
Fig. 7.12 Lift and Tilt Front Panel Cover
and Disconnect Display Cable