Xante FilmMaker 4 User Manual page 253

Fig. 7.13 Remove Front Side Cover
4. Remove the controller assembly.
a. Remove the six screws (numbered; fig. 7.14) securing the controller
assembly to the printer's left side.
b. Remove the power cord ferrite (if one is attached) by opening its side
latch and lifting it off the cord (fig. 7.15).
Fig. 7.15 Remove Ferrite if Necessary
c. Disconnect the controller power cord by pulling it gently straight out
from the controller board (fig. 7.16).
d. Ease the controller assembly out of the printer (fig. 7.17), freeing the
video connector from its socket. Make sure to slide the power cord down
and out through the cord opening in the bottom of the controller
assembly.
6
4
5
Fig. 7.14 Remove Assembly Securing Screws
Fig. 7.16 Disconnect Controller Power Cord
1
2
3
Options 7-9