Xante FilmMaker 4 User Manual page 246

2. Place the feeder on a level, sturdy surface that meets the guidelines in "Printer
Location" in chapter 1 (fig. 7.1).
Fig. 7.1 Paper Cassette Feeder
3. Make sure the printer displays a Please Wait or Ready/Idle message. Then, turn
off the printer, disconnect the power cord from the power supply, and
disconnect all interface cables.
4. Remove all media from the multipurpose feeder and the output tray; then, close
the multipurpose feeder.
5. Pull the cassette out until it stops; then, lift up slightly and remove it from the
printer.
The printer weighs approximately 58.5 lbs (26.5 kg) without the toner, cassettes, and
media installed. Always have two people lift the printer using the recessed grip areas
on the right and left sides.
6. Lift the printer over the feeder and align the two stubs on the feeder with the
holes on the bottom of the printer (fig. 7.2). Then, lower the printer onto the
feeder. The feeder's stubs should fit easily into the printer's holes.
Fig. 7.2 Align Printer over Feeder
7-2 Options
Fig. 7.3 Secure Printer to Feeder