Postscript Features (Accelafont, Dpi, Linearization, Lpi, Margins, More X-Act, And Vm) - Xante FilmMaker 4 User Manual

2. Select Printer Configuration: Network: TCP/IP (fig. 3.99). The TCP/IP
Configuration window appears (fig. 3.100).
3. Check and change the following settings accordingly if necessary (fig. 3.100).
a. Change the TCP/IP address Network Class if necessary (check with your
System Supervisor); then, click Change.
b. Change the printer's default TCP/IP address (Network and Node IDs) to
the address assigned by your System Supervisor by using the scroll arrows
beside each number; then, click Change.
c. Change the Subnet Mask if necessary; then, click Change. If you are using
DHCP, continue to step 4.d; otherwise skip to step 4.
d. Select either DHCP On or DHCP Off and click Change.
4. Close your browser; then, restart your printer to make the new TCP/IP address
take effect.

PostScript Features (AccelaFont, DPI, Linearization, LPI, Margins, More X-ACT, and VM)

PostScript features include AccelaFont, DPI, Linearization, LPI, Margins, and More
X-ACT options.
AccelaFont
AccelaFont options allow you to set aside a portion of RAM disk to store fonts for
quick system access. AccelaFont automatically loads the most recently used fonts from
the printer's optional hard disk into the RAM disk. This eliminates time usually
required to access fonts from the hard disk. AccelaFont is active only if fonts are
downloaded to an optional hard disk on the printer and RAM Disk is enabled for 1
MB or more.
You also can set this feature using the front panel Utility: Font Accel configuration
menu. Options are
1. Go to the printer home page (fig. 3.101). See "Printer Home Page" earlier in
this chapter for details.
3-48 PC Setup