Xante FilmMaker 4 User Manual page 4

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Shielded cables must be used with this unit to ensure compliance with the FCC Class A limits.
Power Information
100/120 V Version:100/120 VAC (90-132 V), 50/60 Hz (47-63 Hz), 6.5 A
220/240 V Version:220/240 VAC (198-264 V), 50/60 Hz (47-63 Hz), 3.2 A
Power Cord
The power cord is the main disconnect device. It should be plugged into an easily accessible
outlet.
For 115 Volt Configuration:
The power cord to be used with 115 Volt configuration is minimum type SJT (SVT)
18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15 feet. One terminated
in an IEC 320 attachment plug. The other end is terminated in a NEMA 5-15P plug.
For 230 Volt Configuration
The power cord to be used with 230 Volt configuration is minimum type SJT (SVT)
18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15 feet. One terminated
in an IEC 320 attachment plug. The other end is terminated as required by the
country where it will be installed.
Le cable de transport d'energie que doit etre utilis'e la configuration 230 Volts est le
type minimum SJT (SVT), 18/3, nominal 250 Volts ac, 10 Amps, 4.5 m long
maximum. Un bout est raccorde comme exige par le pays ou il sera utilis'e.
Das Netzkabel ist das haupfsachliche Diskonnektionsmittel, es sollte in eine leicht
erreichbare steckdos gesteckt werden.
Das Netzkabel kann mit einer 230 Volts Konfiguration verwonder werden vom typ:
Minimum VDE or HAR, 3 X 1.00 mm
Ende ontspriche dem Stecker IEC 320. Das andoro Ende entspricht den
Anfoderungen des entsprechenden Landes.
ivbb
2
, 250 V ac, 10 Amps, maximal 4.5 m long. Ein