Xante FilmMaker 4 User Manual page 191

Also, it is not necessary to measure for each coverage value listed in the Densitometer
Data Entry window, but it is recommended to do so to achieve more accurate results.
10. Click Graph to display a curve of your printer's linear curve. Then, click
Linearize to continue. The Linearization window reappears (fig. 3.170).
If you need to stop linearization (for example, to change the media type), you can
click Cancel to stop.
11. Click Save to printer (fig. 3.170) if you want to save the data file for future use.
Then, specify a new file name and select a folder for saving the file. Click Save.
Otherwise, skip to step 12.
12. Click OK to close the Linearization window.
If you want to verify linearization, click the Verify Calibration button (fig. 3.170)
before you close the Linearization window. When this page prints, compare it to the
original calibration page to verify the gamma correction; you should see an
improvement in grayscale progression.
Advanced Gamma Control
If you are an expert user, you may want to adjust image lowlights, midtones,
highlights and details in a gamma curve using the Advanced option in the
Linearization window (fig. 3.170).
You cannot see the advanced window adjustments on screen. Unless you are an
advanced user, you should make these adjustments through an application.
1. Select the gamma curve to update from Update Transfer Curve in the
Linearization window (fig. 3.171)
PC Setup 3-79