Xante FilmMaker 4 User Manual page 138

4. Power cycle the printer (turn off, then back on).
5. Using a word processing application, open setipsub.ps file from the ps_files
folder. Edit the file so it contains the IP, Subnet, and Gateway addresses you
obtained from your network administrator. Save the file to your c:\ drive.
6. Go to DOS (Command) Prompt.
7. Type the following, substituting the appropriate port if necessary:
8. Power cycle the printer again and verify that the start-up page contains your IP,
Subnet, and Gateway addresses.
9. Go to DOS (Command) Prompt to ping the printer. Then, type the following
(substituting the correct IP address for <IP ADDRESS>; for example if your IP
address is 192.9.200204. you would type PING 192.9.200204 ↵ at the DOS
prompt.
If you can ping the printer, go on to step 10. If you cannot ping your printer, contact
your Network Administrator.
10. Go back to your Printer Properties and select the Ports tab (fig. 3.53).
3-26 PC Setup
COPY DHCPOFF.PS LPT1 ↵
COPY SETIPSUB.PS LPT1 ↵
C:\PING <IP ADDRESS> ↵