Xante FilmMaker 4 User Manual page 254

Video
Connector
Fig. 7.17 Remove Controller Assembly
5. Remove the controller board from its housing.
a. Locate and remove the seven screws (numbered; fig. 7.18) securing the
controller board to the controller housing.
6
5
Fig. 7.18 Remove Screws Securing Board
b. Lift the board away from the back of the controller housing until the
video connector clears the housing. The video connector is on the back of
the controller board close to the upper edge (fig. 7.19).
c. Grasp the interface plate (fig. 7.19) and slide the board unit left until it
clears the metal tabs that secure it to the housing.
d. Shift the controller board unit out of the housing until it clears the metal
tabs on the controller housing.
7-10 Options
Cord
Opening
7
1
2
3
4
Video
Connector
Housing
Fig. 7.19 Remove Board from Housing
Board
Interface
Plate