Locating Jams - Xante FilmMaker 4 User Manual

- Follow the guidelines for the type of media you are using. See "Media
Types" in chapter 5.
- Make sure media is loaded according to the procedures and guidelines in
"Standard Cassette" and "Multipurpose Feeder" in chapter 1 and "Media
Sources" in chapter 5.
• Make sure the output tray does not become overfilled.
• Remove all media from the multipurpose feeder before turning on the printer.
Reinsert the media when the printer displays the Ready/Idle message.
• Use XANTÉ supplied toner.
• Use XANTÉ Myriad film.
• Keep the printer clean. See "Cleaning the Printer" in chapter 6. Use the cassette
cover to prevent dust and debris from settling on the media and getting into the
printer.

Locating Jams

Media Jams occur along the paper path in the areas illustrated in figure 8.1
D
B
Fig. 8.1 The Printer Paper Path
• In the media source (either a paper cassette or the multipurpose feeder) and the
toner cartridge (A)
• In the back of the paper feeder (B)
• Around the toner cartridge (C)
• In the paper exit area under the fuser cover (D)
Use one of the following two procedures to locate a media jam; then see "Clearing
Media Jams" later in this chapter for details on removing the jam.
C
A
Troubleshooting 8-13