Controller Board Upgrades; Removing The Controller Board Panel - Xante FilmMaker 4 User Manual

Controller Board Upgrades

RAM, 2400 dpi resolution, NEIT (includes Positive Film Technology), and internal
IDE hard disk upgrades are controller board modifications. This section covers
installing RAM memory and IDE upgrades; the 2400 dpi resolution is a factory
installed upgrade.
A controller board upgrade installation involves accessing the controller board,
installing the upgrade(s), and reassembling the printer.
Static electricity can destroy electronic components, such as your controller board,
SODIMMs, firmware, and the hard disk. Use approved anti-static procedures when
working with the controller board and upgrades.

Removing the Controller Board Panel

1. Make sure the printer displays a PLEASE WAIT or READY/IDLE message.
Then, turn off the printer and disconnect the power cord and all interface
cables.
2. Remove any media in the multipurpose feeder and output tray.
3. Loosen the two screws on the back of the printer that secure the controller
board access panel to the printer (fig. 7.5).
Fig. 7.5 Loosen Panel Screws
4. Slide the panel toward the back of the printer until it stops. Pull the panel down
and out to remove it from the printer (fig. 7.6).
7-4 Options
Fig. 7.6 Remove Panel