Table of Contents
Advertisement
1.4. Board Power On
The Mercury A2700 Accelerator Card can be used in stand-alone or be installed to the
Host through PCIe slot. This section will introduce how to power on the board and the
information that user should notice in these two modes.
Stand-alone Mode
When the Mercury A2700 Accelerator Card is used in stand-alone mode, users can
use the 12V ATX power provided in the kit to connect to the 8-pin 12V ATX power
connector (See
Figure
board, user need to turn the power switch SW2 to "ON" position.
Install to Host
When the Mercury A2700 Accelerator Card is installed on the Host via PCIe slot.
Although the Host can provide power to Mercury A2700 Accelerator Card via PCIe slot,
but Terasic strongly recommends that users connect an external power (through the
MA27
User Manual
1-2) of the Mercury A2700 Accelerator Card. To power up the
Figure 1-2 Board Power Control Switch
7
www.terasic.com
February 17,
2024
Advertisement
Table of Contents
