3.
Specify the configuration of the FPGA using the default Factory Configuration
Image or User Configuration Image by setting SW4 according to Figure 3-3. When
the switch is in position "1", the factory image is used when the system boots.
When the switch is in position "0", user image is used when the system boots.
4.
Power on the FPGA board or press the MAX_RST button if board is already
powered on,
5.
When the configuration is completed, the green Configure Done LED will light. If
there is an error, the red Configure Error LED will light (See
MA27
User Manual
Figure 3-2 Position of the MSEL[2:0] switch
87
Figure
3-4).
www.terasic.com
February 17,
2024