Table of Contents
Advertisement
2.2
Configuration
This section describes the configuration mode for intel Agilex® 7 device available on
the board. The peripheral circuits and usage scenarios for each mode will be listed.
To switch these methods on the board, the user needs to switch the MSEL[2:0] pin of
FPGA on SW4 and SW5 to change the configuration methods (See
details, please refer to Setup Configure Mode part of the section 2.3.
Avalon-ST x8 (MSEL[2:0] =
JTAG Mode (MSEL[2:0] = 3'b111 Configure the FPGA using the on-bo
ard USB Blaster II).
Active Serial Fast mode (MSEL[2:0] = 3'b001)
MA27
User Manual
Figure 2-2 FPGA Board (Bottom)
3'b110/Default
13
Figure 2-3
Setting)
www.terasic.com
February 17,
). For
2024
Advertisement
Table of Contents
