Rear Wheel Twinning (710/70R42 + 710/70R42) - Belarus 3522.5 Operator's Manual

4.2.11 Rear wheel twinning
With an aim to improve gripping properties of the tractor when coupled with heavy
agricultural implements on soils with low bearing capacity, rear wheel twinning with use of
spacers is provided.
The additional wheels are mounted one by one, in the following way:
- set a min. permissible track for the main rear wheels, as specified in subsection
4.2.10 "Rear wheel track formation";
- put stops under the front and the rear wheels;
- jack up the tractor rear part;
- unscrew the securing nuts of the right and the left rear wheels and put them aside;
- put washers 2, included into the spacer kit, on bolts 1 (figure 4.2.7);
- secure the inner wheel with special bolts 3, included into the spacer kit, with a
torque of 700 to 750 N·m;
- mount the other supplementary wheel;
1 – hub bolt; 2 – washer; 3 – special bolt; 4 – nut; 5 – wheel nut.
Dimensions for the track of the twinned rear wheels are given in table 4.5.
Table 4.5 – Dimensions for the track of the rear twinned wheels
Tires
650/75 R42
710/70 R42
__________________________________________________________________
1)
Referential dimensions
Information on choosing optimal inner pressure for tires when operating "BELARUS-
3522.5" tractor with rear wheels twinned is presented in subsection 4.2.9 of this manual.
Operation pecularities of "BELARUS-3522.5" completed with twinned wheels are
provided in section 5 "Coupling of implements".
Figure 4.2.7 – Diagram of rear wheel twinning
1)
А
, mm
383
600
https://tractormanualz.com/
1)
Е К1, mm
, mm
57 1900-2040
2020-2140
120
228
3522.5-0000010 РЭ
К2, mm
3314-3454
3692-3812