YASKAWA GA500 Maintenance & Troubleshooting page 25

Screw
Screw Shape
Size
*1
M5
M6
(WAF: 5 mm)
*1 When you wire drive models 2042, 2056, 4031, 4038, 4044, and 4060, select the correct tools for the wire gauge.
*2 Use 6.35 mm (0.25 in) bit socket holder.
*3 Use a torque wrench that can apply this torque measurement range.
■
Remove the Control Circuit Board
Remove the front cover and keypad from the drive.
1.
Push the tabs to the left that hold the control board to the drive.
2.
Pull the left side of the control circuit board out first.
■
Put the Control Circuit Board in a New Drive
Remove the keypad, front cover, and control circuit board of the new drive.
Wire the main circuit terminals of the new drive, then attach the wired control circuit board.
YASKAWA TOEPYAIGA5001A GA500 DRIVE MAINTENANCE & TROUBLESHOOTING
Wire Gauge Adapter
≤ 25 mm 2
(AWG 10)
Bit SF-BIT-SL 1,2X6,5-70
≥ 30 mm 2
(AWG 8)
- Bit SF-BIT-HEX 5-50
Figure 1.20 Unhook the Tabs
Figure 1.21 Remove the Control Circuit Board
Bit
Model Manufacturer
PHOENIX CONTACT
PHOENIX CONTACT
1.5 Replace the Drive
Torque Driver Model Torque Wrench
(Tightening Torque) (Tightening Torque)
TSD-M 3NM
-
(1.2 - 3.0 N∙m
(10.6 - 26.6 lbf∙in))
4.1 - 4.5 N∙m
-
(36.3 - 39.8 lbf∙in)
5 - 9 N∙m
-
(44.3 - 79.7 lbf∙in)
*2 *3
*2 *3
1
25