General Information About Working With The Lds; Enter User-Defined Device Name; Open „Device Control" Menu - Primes FocusMonitor FM+ Original Instructions Manual

Laser beam diagnostic system
Hide thumbs Also See for FocusMonitor FM+:
Table of Contents

Advertisement

9.4

General information about working with the LDS

This chapter contains general information about the LDS, irrespective of the respective measuring task.
Read this general information before turning to the following chapters on the various measurement modes.
9.4.1

Enter user-defined device name

If you want to assign a user-defined device
name to a device, proceed as follows:
1.
Click on the Devices tab.
2.
Right-click on the device and select
the Device settings menu point.
3.
Enter the desired device name in the
Device name input field
(max. 18 characters).
4.
In the Device settings window, confirm
the entry with OK.
The Confirmation window appears.
5.
Place a check mark at Acknowledge
and click OK.
6.
Switch the device off and on again.
 The device name is displayed in the
Connections window.
 After connecting, the device name is
displayed in the Devices tab.
9.4.2
Open „Device control" menu
1.
Click on the Devices tab.
2.
Select the device and click on the
device function Scanner below the
device name.
The Device control menu with the
following sections opens.
Adjustment
(see chapter 9.4.3 on page 33)
Measuring modes
(see chapter 9.4.4 on page 34)
32
Device function
Measuring modes
FocusMonitor FM+
Adjustment
Revision 08 EN - 08/2023

Advertisement

Table of Contents
loading

Table of Contents