Table of Contents
Advertisement
FocusMonitor FM+
9.5
Settings that apply in all measuring modes
9.5.1
Define locked area
The Locked area in the Device control > Advanced menu enables a spatial restriction of the measuring
range in y- and z-direction. The defined locked area is not entered by the horizontal and vertical carriers. A
locked area can be set in the individual measuring modes and is adopted in all measuring modes.
For standard installation
The position z=0 and y=0 defines the
lower left corner of the locked area as
park position.
The z-coordinate of the point P1 cannot
be changed.
1.
After opening the Device Control
menu, click the Advanced button.
2.
Use one of the following options:
X Enter the locked area in the P1, P2,
P3 input fields.
X Press the left mouse button and drag
the red dots.
3.
Press the Save device settings button.
The locked area is saved and applied
to all measurement modes.
Revision 08 EN - 08/2023
z
z=100 mm
Locked area
Laser
y
z=120 mm
Park position
z=0 mm
37
Advertisement
Table of Contents
