Table of Contents
Advertisement
FocusMonitor FM+
9.5.5
Rotating the measuring tip
In case of limited accessibility in the laser system, the device can be mounted in an upside down orientation
with rotated measuring tip. The curved side of the measuring tip must always face the incident laser beam.
If the measuring tip of the device is rotated, e.g. to perform an „upside down" measurement, this must be set
and saved in the LDS.
The coordinates given as the z-position when measuring always relate to the device coordinate system,
which changes when the device or measurement tip is rotated.
See chapter 9.5.6 „Coordinate system for rotated measuring tip" on page 42.
Please note that a previously defined locked area is reset when changing the orientation.
1.
After opening the Device Control
menu, click the Advanced button.
2.
Click one of the < > buttons.
The illustration of the device rotates
180 degrees.
3.
Click the Save device parameters
button.
The window Rotated tip is displayed.
4.
Check the Acknowledge box and
click OK.
The rotated measuring tip is stored in
the LDS.
A previously defined locked area is
reset.
Revision 08 EN - 08/2023
41
Advertisement
Table of Contents
