Table of Contents
Advertisement
Series measurement using z-increment spacing:
The combination of the Time series and z-Increment in
mm options enables measuring a free caustic in one run.
1.
Click on the Settings tab.
2.
Enter the spacing for the planes to be measured in
the z-Increment in mm field.
3.
In the Number of measurements and Interval
between measurements in s input fields, enter the
number of measurements and the interval. The interval
is the time between the end of one measurement and
the start of the next.
4.
Start the series measurement according to
chapter 9.8.4 „Start measurement" on page 54
and wait until the measurement is finished.
9.8.4
Start measurement
1. Observe the warning messages in
chapter 9.1 „Warning messages" on
page 27.
2.
Click the Start button.
The measurement begins.
Optional:
X Click the Stop button to abort the
measurement.
X Click the Stop Rotation button to
stop the rotation of the measuring tip.
During the measurement, the progress
is shown in the following indicators:
Measurement:
While the indicator is rotating, the measure-
ment is performed.
Measurement completed:
After successful measurement, the indicator
lights up green.
Averaging (if enabled):
The indication shows the measured planes
that are used to average a measured value.
3.
Switch off the laser after the measure-
ment is completed, unless you want
to perform further measurements.
54
FocusMonitor FM+
Revision 08 EN - 08/2023
Advertisement
Table of Contents
