Table of Contents
Advertisement
1. Switch off the laser beam.
2. Ensure that moving parts, e.g. robot arms, etc. are at a standstill and that they cannot be set in motion
unintentionally.
3. Check the space available before installing the device, especially the required space for the connection
cables and hoses.
Range of motion
Fig. 7.2:
The range of motion of the horizontal and vertical carrier can be restricted in the LDS (locked area).
A locked area can be set according to chapter chapter 9.5.1 „Define locked area" on page 37.
7.2.2
Possible mounting positions
The device can be installed in any mounting position. The position and diameter of the mounting holes on the
top and bottom of the device are identical.
Standard installation
The standard position of the device is intended for a beam incidence from above.
Upside down installation with rotated measuring tip
In case of limited accessibility in the laser system, the device can be mounted in an upside down installation
with rotated measuring tip. Due to the symmetrically designed housing, upside down mounting is possible
without additional components, see chapter 11.3 „Check/replace the measuring tip" on page 68.
Installation with horizontal beam incidence
For operation with horizontal beam incidence, the device can also be installed on a vertical mounting surface.
The device can be mounted with the carriers pointing up or down. Pay particular attention to secure fastening
in this mounting position.
Standard installation
Mounting surface
Beam incidence
Mounting surface
Fig. 7.3:
Possible mounting positions of the device
18
z=120 mm
of the horizontal and vertical carrier
Upside down installation
with rotated measuring tip
Mounting surface
Mounting surface
y= max. 22 mm
horizontal beam incidence
Beam incidence
FocusMonitor FM+
Installation with
Revision 08 EN - 08/2023
Advertisement
Table of Contents
