Table of Contents
Advertisement
Assemble detector
NOTICE
Blocking the rotational disc
Do not forget the foam rubber spacer during installation, otherwise the rotational disc could be
mechanically blocked by the screws.
The foam rubber spacer also ensures mechanical isolation of the detector.
X Only tighten the plastic screws hand-tight. The foam rubber spacer must only be compressed to
no less than half its original thickness.
Only use isolating plastic screws to fasten the detector to prevent any electric noise signals from
being interspersed.
1.
To install the new detector, first place
the foam rubber spacer (C) (included
in the scope of delivery) on the
mounting surface of the detector.
2.
Then connect the cables (A) and (B).
3.
Center the detector to the housing.
4.
Fasten the detector with the two
plastic screws (D).
X Only tighten the plastic screws hand-
tight. The foam rubber spacer must
only be compressed to no less than
half its original thickness.
72
C
D
D
B
A
Maintain distances!
D
D
Revision 08 EN - 08/2023
FocusMonitor FM+
Advertisement
Table of Contents
