Table of Contents
Advertisement
9.4.6
Saving options
The LDS offers (up to) three different options for saving. They differ by the storage location and the selection
of the data to be saved.
When saving/loading a configuration, note that the command is called in a certain measurement mode, but
the saved/loaded data set also includes the settings of the other measurement modes.
Save data with asterisk (*) to a file /
load from a file:
All data marked with an asterisk in the
Device control menu can be saved to a
preset file with the extension .pre on the PC.
To save a configuration, click on the icon
X
.
X To load a configuration click on the icon
.
Save data with an asterisk (*) in the
EEPROM of the device:
All options marked with an asterisk in the
Device control menu can be saved in the
EEPROM in the device.
In this case, the settings will be retained even
if the device is switched off or disconnected
from the power supply.
1.
Click on the Advanced tab.
2.
Click on the Save device settings
button.
Save all settings in the LDS:
With these buttons you can save or load
all settings of the Device control menu.
The storage is made device-related in the
local installation of the LDS.
1.
Click on the Settings tab.
2.
Use one of the following options:
X Click the Save current parameters
button to save the settings of the
connected device.
X Click on the Load last parameters
button to load the last saved settings.
36
FocusMonitor FM+
Revision 08 EN - 08/2023
Advertisement
Table of Contents
