Table of Contents
Advertisement
4.3
Explanation of the product safety labels
A potential hazard area for hand injuries is marked with a symbol "Hand injuries warning" on the device.
Warning of hand injuries due to the rotating measuring tip
The measuring tip of the FM+ rotates at high speed during the measuring operation. Even after the measurement
or switching off the device, the measuring tip will continue to rotate for a certain period of time.
To avoid hand injury, do not reach into the device aperture when the measuring tip is rotating.
If the rotating measuring tip hits an obstacle, the measuring tip will be damaged. In this case, the device
must be sent in for service. Therefore, no objects may be held in the beam path of the device.
After switching off the rotation or the device, wait for the measuring tip to come to a standstill (observe the
„Rotation" status display), see chapter 4.2 „Status Display" on
Fig. 4.3:
Risk of injury due to a rotating measuring tip
Warning of hand injuries in the travel range of the carriers
The horizontal and vertical carrier can be moved relative to the housing. Do not reach into the movement
range of the carriers.
Fig. 4.4:
Risk of injury in the travel range of the carriers
14
page 13).
z-axis
FocusMonitor FM+
Revision 08 EN - 08/2023
Advertisement
Table of Contents
