Table of Contents
Advertisement
FocusMonitor FM+
9
Measuring with the LaserDiagnosticsSoftware LDS
This chapter describes measurements with the LDS. For a detailed description of the software installation,
file management and evaluation of the measured data, please refer to the separate operating manual "LDS".
9.1
Warning messages
DANGER
Serious eye or skin injury due to laser radiation
Depending on the measuring principle used, the laser beam is reflected at the measuring tip (laser class 4).
The reflected beam is usually not visible.
X Please wear safety goggles adapted to the power, power density, laser wavelength and operating
mode of the laser beam source in use.
X Wear suitable protective clothing and protective gloves.
X Protect yourself from laser radiation by separating protective devices
(e.g. by using appropriate shielding).
X During measurements, a safety distance of one meter to the FM+ must be maintained even when
wearing safety goggles and safety clothing.
DANGER
Serious eye or skin injury due to laser radiation
If the device is moved from its aligned position, increased scattered or directed reflection of the laser
beam can occur during measuring operation (laser class 4).
X Mount the device so that it cannot be moved by an unintentional contact or cables being pulled
accidentally.
DANGER
Fire and explosion hazards due to scattered or directed laser radiation
When the FM+ is being operated, the irradiation must be fully absorbed after passing through the
measurement zone. Fire bricks or other partly-absorbing surfaces are not suitable.
X Use an adequate absorber. Depending on the application, PRIMES offers suitable laser power meters.
Revision 08 EN - 08/2023
27
Advertisement
Table of Contents
