Table of Contents
Advertisement
FocusMonitor FM+
7
Mounting
7.1
Conditions at the installation site
•
The device must not be operated in a condensing atmosphere.
•
The ambient air must be free of gases and aerosols that interfere with the laser radiation
(e.g. organic solvents, cigarette smoke, sulfur hexafluoride).
•
Protect the device from splashes of water and dust.
•
Operate the device in closed rooms only.
7.2
Installation in the laser system
DANGER
Fire and explosion hazards due to scattered or directed laser radiation
During operation of the FM+, the irradiation must be fully absorbed after passing through the mea-
surement area. Fire bricks or other partly-absorbing surfaces are not suitable.
X Use an adequate absorber. Depending on the application, PRIMES offers suitable laser power meters.
NOTICE
Damage/Destruction of the device
Obstacles in the travel range of the horizontal and vertical carrier can lead to collisions and damage
the unit.
X Keep the travel range of the horizontal and vertical carrier free of obstacles
(cutting nozzle, pressure rolls, etc.).
X Note that the horizontal and vertical carrier automatically move to the park position after the device
has been switched off and on again.
7.2.1
Prepare mounting
Mounting preparation
To prevent damage during transportation, the measuring tip is removed when delivered. It is installed with the
curved side facing the laser beam.
X Mount the measuring tip according to chapter 11.3 on page 68.
Fig. 7.1:
Measuring tip
Revision 08 EN - 08/2023
Pinhole
17
Advertisement
Table of Contents
