Table of Contents
Advertisement
FocusMonitor FM+
9.5.2
Move axes
Move axes in the Device Control > Advanced menu contains options for moving the vertical and horizontal
carrier. Move axes can be set in the individual measuring modes and is adopted in all measuring modes.
See chapter 9.12.1 „Distance of the pinhole to the horizontal carrier" on page 64.
Option
y-Position in mm
Move to y-position
z-Position in mm
Move to z-position
Move to focus of selected caustic
Tab. 9.2:
Options in the Move axes area of the Device control > Advanced menu
Revision 08 EN - 08/2023
Explanation
X Enter the desired y-position in the input field or use the slider.
X Click this button to move the horitontal carrier to the y-position
specified in the y-Position in mm field.
Note that this does not have to be the maximum traversing range of
your device. If a locked area of the z-axis was stored in the EEPROM
during a previous use of the device, then this locked area is active.
X Enter the desired z-position in the input field or use the slider.
X Click this button to move the vertical carrier to the z-position specified
in the z-Position in mm field.
Note that this does not have to be the maximum traversing range of
your device. If a locked area of the z-axis was stored in the EEPROM
during a previous use of the device, then this locked area is active.
1.
Select a caustic in the project tree (see separate operating manual
of the LaserDiagnosticsSoftware LDS).
2.
Click this button to move the vertical slide to the z-position of the
focus position.
Note that the focus should not be in the locking range of the z-axis. If a
locked area of the z-axis was stored in the EEPROM during a previous
use of the device, then this locked area is active and the selected caustic
cannot be approached.
39
Advertisement
Table of Contents
