HPE ProLiant DL365 Gen11 Maintenance And Service Manual page 52

4. Remove the access panel .
5. Remove the riser cage.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card Removing and replacing an expansion card
About this task About this task
Use these instructions to remove and replace expansion boards such as Smart I/O cards (such as the Pensando DSP DSC-25 2p SFP28 card),
solid state NVMe/PCIe Add-In-Cards, HBAs, CNAs, InfiniBand adapters, and accelerators.
WARNING: WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from the server
by removing the power cord. The front panel Power On/Standby button does not shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Remove the riser cage.
6. If a retaining screw is installed, remove the screw.
7. Remove the expansion card from the riser cage.
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 52