HPE ProLiant DL365 Gen11 Maintenance And Service Manual page 56

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the serial port Removing and replacing the serial port
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Remove all riser cages .
6. Disconnect the serial port cable from the system board .
7. Remove the serial port:
a. Remove the hex screws (callout 1).
Retain screws for future use.
b. Detach the serial port from the rear panel (callout 2).
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 56