HPE ProLiant DL365 Gen11 Maintenance And Service Manual page 44

Removing and replacing an M.2 SSD Removing and replacing an M.2 SSD
About this task About this task
This procedure is for drives on the system board, riser, or expansion card. Do not use this procedure on uFF drives.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Remove the primary riser cage.
6. Remove the M.2 SSD.
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 44