HPE ProLiant DL365 Gen11 Maintenance And Service Manual page 85

Front panel LEDs and buttons Front panel LEDs and buttons
Item Item Description Description
1 Power On/Standby button
and system power LED
2 Health LED
1
3 NIC status LED
1
3
4 UID button/LED
1
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
3
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
Rear panel components Rear panel components
Status Status
Solid green = System on
1
Flashing green = Performing power on sequence
Solid amber = System in standby
Off = No power present
Solid green = Normal
Flashing green = iLO is rebooting.
Flashing amber = System degraded
Flashing red = System critical
Solid green = Link to network
Flashing green = Network active
Off = No network activity
Solid blue = Activated
Flashing blue:
1 Hz = Remote management or firmware
upgrade in progress
4 Hz = iLO manual reboot sequence initiated
8 Hz = iLO manual reboot sequence in progress
Off = Deactivated
1
2
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 85