HPE ProLiant DL365 Gen11 Maintenance And Service Manual page 80

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the 8 SFF drive backplane Removing and replacing the 8 SFF drive backplane
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Remove all drives and drive blanks.
Note where each drive is located.
6. If installed, remove the Smart Storage Battery ( Removing and replacing an energy pack ).
7. Disconnect and remove all cables from the drive backplane.
8. Remove the drive backplane.
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 80