4.
CONFIGURATION
4.1.
ACCESSING THE SERIAL PORT MENU
Connect a serial cable to the UPGRADE port at the back of the unit. Do not connect any Ethernet cables
to the unit (failure to do this could cause unwanted network issues) until the initial configuration has been
completed. Connect the 9-pin D-type end of the serial cable to the serial port of your computer. Open a
terminal session and configure the port for the following configuration:
4.2.
SERIAL MENU
Configure your terminal program to the table settings in Table 4-1 and press the <enter> button. The
session should respond with the 2432RX2-HDMI Main Menu.
UPGRADING FIRMWARE
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
Table 4-1 : Serial Port Terminal Settings
Figure 4-1 : 2432RX2-HDMI Serial Menu
Revision 1.0
Dual Path Serial Digital to HDMI Converter
115200
8
None
2
None
2432RX2-HDMI
Page - 11