2432TX-2
Dual Path Dual Link DVI to Serial Converter
4.2.
ACCESSING THE SERIAL PORT MENU
Connect a serial cable to the UPGRADE port at the back of the unit. Do not connect any Ethernet cables
to the unit (failure to do this could cause unwanted network issues) until the initial configuration has been
completed. Connect the 9-pin D-type end of the serial cable to the serial port of your computer. Open a
terminal session and configure the port for the following configuration:
4.3.
SERIAL MENU
Configure your terminal program to the above table settings and press the <enter> button. The session
should respond with the 2432TX-2 Main Menu.
Page 10
Figure 4-2: 2432TX-2 DIP Switches
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
Table 4-2: Serial Port Terminal Settings
Figure 4-3: 2432TX-2 Serial Menu
Revision 1.0
115200
8
None
2
None
STATUS LEDS