Table of Contents
Advertisement
Managing Physical Interfaces
2
Basic Parameters Configurations
2.1
Using the GUI
Choose the menu L2 FEATURES > Switching > Port > Port Config to load the following
page.
Figure 2-1 Configuring Basic Parameters
Follow these steps to configure basic parameters for the ports:
1) Configure the MTU size of jumbo frames for all ports, then click Apply.
Jumbo
2) Select one or more ports to configure the basic parameters. Then click Apply.
UNIT/LAGS
Type
Configure the size of jumbo frames. By default, it is 1518 bytes.
Generally, the MTU (Maximum Transmission Unit) size of a normal frame is 1518
bytes. If you want the switch supports to transmit frames of which the MTU size is
greater than 1518 bytes, you can configure the MTU size manually here.
Click the UNIT number to configure physical ports. Click LAGS to configure LAGs.
Displays the port type. Copper indicates an Ethernet port, and Fiber indicates an
SFP port.
Basic Parameters Configurations
Configuration Guide
95
Advertisement
Table of Contents
