Table of Contents
Advertisement
Configuring 802.1x
Follow these steps to add a RADIUS server:
1) Configure the parameters of the RADIUS server.
Server IP
Shared Key
Authentication
Port
Accounting
Port
Retransmit
Timeout
NAS Identifier
2) Click Apply.
Configuring the RADIUS Server Group
Choose the menu SECURITY > AAA > Server Group to load the following page.
Figure 2-2 Adding a Server Group
Follow these steps to add the RADIUS server to a server group:
1) Click
group.
If you click
Enter the IP address of the server running the RADIUS secure protocol.
Enter the shared key between the RADIUS server and the switch. The RADIUS
server and the switch use the key string to encrypt passwords and exchange
responses.
Specify the UDP destination port on the RADIUS server for authentication
requests. The default setting is 1812.
Specify the UDP destination port on the RADIUS server for accounting requests.
The default setting is 1813.
Specify the number of times a request is resent to the server if the server does not
respond. The default setting is 2.
Specify the time interval that the switch waits for the server to reply before
resending. The default setting is 5 seconds.
Specify the name of the NAS (Network Access Server) to be contained in RADIUS
packets for identification. It ranges from 1 to 31 characters. The default value is the
MAC address of the switch. Generally, the NAS indicates the switch itself.
to edit the default radius server group or click
, the following window will pop up. Select a RADIUS server and click Save.
802.1x Configuration
to add a new server
Configuration Guide
543
Advertisement
Table of Contents
