TP-Link T1500 Series User Manual page 582

Hide thumbs Also See for T1500 Series:

Table of Contents

Configuring 802.1x

Figure 3-6 Configuring Port

3.5 Using the CLI

1) Configure the RADIUS parameters.

Switch_A(config)#radius-server host 192.168.0.10 auth-port 1812 key 123456

Switch_A(config)#aaa group radius RADIUS1

Switch_A(aaa-group)#server 192.168.0.10

Switch_A(aaa-group)#exit

Switch_A(config)#aaa authentication dot1x default RADIUS1

2) Globally enable 802.1x authentication and set the authentication protocol.

Switch_A(config)#dot1x system-auth-control

Switch_A(config)#dot1x auth-protocol eap

3) Disable 802.1x authentication on port 1/0/2 and port 1/0/3. Enable 802.1x

authentication on port 1/0/1, set the control mode as auto, and set the control type as

Switch_A(config)#interface fastEthernet 1/0/2

Switch_A(config-if)#no dot1x

Switch_A(config-if)#exit

to save the settings.

Configuration Example

Configuration Guide