Table of Contents
Advertisement
Configuring DHCP Service
In this example, the DHCP server is demonstrated with T1500G-10PS and the DHCP
relay agent is demonstrated with T1500G-28PCT. This chapter provides configuration
procedures in two ways: using the GUI and using the CLI.
4.3 Using the GUI
Configuring the DHCP Server
1) Choose the menu L3 FEATURES > DHCP Service > DHCP Server > DHCP Server to
load the following page. In the Global Config section, enable DHCP Server globally.
Figure 4-2 Configuring DHCP Server
2) Choose the menu L3 FEATURES > DHCP Service > DHCP Server > Pool Setting and
click
the corresponding parameters as the following picture shows.
Figure 4-3 Configuring DHCP Pool 1 for VLAN 10
Configuring the VLANs on the Relay Agent
3) Choose the menu L2 FEATURES > VLAN > 802.1Q VLAN > VLAN Config and click
to load the following page. Create a DHCP pool for the clients. Configure
to load the following page. Create VLAN 10 and VLAN 20 for the Marketing
Example for DHCP VLAN Relay
Configuration Guide
412
Advertisement
Table of Contents
