TP-Link T1500 Series User Manual page 346

Hide thumbs Also See for T1500 Series:

Table of Contents

Configuring Spanning Tree

 Configuring the VLAN-Instance Mapping and Switch Priority

Choose the menu L2 FEATURES > Spanning Tree > MSTP Instance > Instance Config to

load the following page.

Figure 3-3 Configuring the VLAN-Instance Mapping

Follow these steps to map VLANs to the corresponding instance, and configure the priority

of the switch in the desired instance:

1) In the Instance Config section, click Add and enter the instance ID, Priority and

corresponding VLAN ID.

Figure 3-4 Configuring the Instance

2) Click Create.

Enter the corresponding instance ID.

Specify the priority for the switch in the corresponding instance. The value

should be an integral multiple of 4096, ranging from 0 to 61440. It is used to

determine the root bridge for the instance. Switches with a lower value have

higher priority, and the switch with the highest priority will be elected as the

root bridge in the corresponding instance.

Enter the VLAN ID to map the VLAN to the desired instance or unbind the

VLAN-instance mapping.

MSTP Configurations

Configuration Guide