TP-Link T1500 Series User Manual page 145

Configuring LAG
Step 9
The following example shows how to specify the system priority of the switch as 2:
Switch#configure
Switch(config)#lacp system-priority 2
Switch(config)#show lacp sys-id
2, 000a.eb13.2397
Switch(config)#end
Switch#copy running-config startup-config
The following example shows how to add ports 1/0/1-4 to LAG 6, set the mode as LACP,
and select the LACPDU sending mode as active:
Switch#configure
Switch(config)#interface range gigabitEthernet 1/0/1-4
Switch(config-if-range)#channel-group 6 mode active
Switch(config-if-range)#show lacp internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in active mode
P - Device is in passive mode
Channel group 6
Port Flags State
Gi1/0/1 SA
Gi1/0/2 SA
Gi1/0/3 SA
Gi1/0/4 SA
Switch(config-if-range)#end
Switch#copy running-config startup-config
copy running-config startup-config
Save the settings in the configuration file.
LACP Port Priority Admin Key Oper Key Port Number Port State
Up 32768
Down 32768
Down 32768
Down 32768
0x6 0x4b1
0x6 0
0x6 0
0x6 0
LAG Configuration
0x1 0x7d
0x2 0x45
0x3 0x45
0x4 0x45
Configuration Guide 123