TP-Link T1500 Series User Manual page 836

Configuring System Logs
The following example shows how to configure the local logs on the switch. Save logs of
levels 0 to 5 to the log buffer, and synchronize logs of levels 0 to 2 to the flash every 10
hours:
Switch#configure
Switch(config)#logging buffer
Switch(config)#logging buffer level 5
Switch(config)#logging file flash
Switch(config)#logging file flash frequency periodic 10
Switch(config)#logging file flash level 2
Switch(config)#show logging local-config
Channel Level
-------
Buffer
Flash 2
Console 5
Monitor 5
Switch(config)#end
Switch#copy running-config startup-config
2.2.2 Configuring the Remote Logs
You can configure up to four hosts to receive the switch's system logs. These hosts are
called Log Servers. The switch will forward the log message to the servers once a log
message is generated. To display the logs, the servers should run a log server software
that complies with the syslog standard.
Follow these steps to set the remote log:
Step 1 configure
Enter global configuration mode.
Status Sync-Periodic
----- ------ -------------
5 enable Immediately
enable 10 hour(s)
enable Immediately
enable Immediately
System Logs Configurations
Configuration Guide 814