TP-Link T1500 Series User Manual page 523

Configuring Access Security
2.2 Using the CLI
2.2.1 Configuring the Access Control
Follow these steps to configure the access control:
Step 1 configure
Enter global configuration mode.
Step 2 Use the following command to control the users' access by limiting the IP address:
user access-control ip-based enable
Configure the control mode as IP-based.
user access-control ip-based { ip-addr ip-mask } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping
] [ all ]
Only the users within the IP-range you set here are allowed to access the switch.
ip-addr
ip-mask
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all
accessing. By default, these types are all enabled.
Use the following command to control the users' access by limiting the MAC address:
user access-control mac-based enable
Configure the control mode as MAC-based.
user access-control mac-based { mac-addr } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [
all ]
Only the users with the MAC address you set here are allowed to access the switch.
mac-addr
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all
accessing. By default, these types are all enabled.
Use the following command to control the users' access by limiting the ports connected to the
users:
user access-control port-based enable
Configure the control mode as Port-based.
user access-control port-based interface { fastEthernet port-list | gigabitEthernet port-list |
ten-gigabitEthernet port-list } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ]
Only the users connecting to the ports you set here are allowed to access the switch.
port-list
most.
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all
accessing. By default, these types are all enabled.
: Specify the IP address of the user.
: Specify the subnet mask of the user.
: Specify the MAC address of the user.
: Specify the list of Ethernet port, in the format of 1/0/1-4. You can appoint 5 ports at
Access Security Configurations
]: Select to control the types for users'
]: Select to control the types for users'
]: Select to control the types for users'
Configuration Guide 501