Table of Contents
Advertisement
Configuring IPv6 IMPB
5.2.4 Using the CLI
1) Manually bind the IPv6 address, MAC address, VLAN ID and connected port number of
the legal host, and apply this entry to the IPv6 Source Guard feature.
Switch#configure
Switch(config)#ipv6 source binding legal-host 2001::5 74:d3:45:32:b6:8d vlan 1
interface fastEthernet 1/0/1 ipv6-verify-source
2) Enable IPv6 Source Guard on ports 1/0/1-3.
Switch(config)# ipv6 verify source
Switch(config)# interface range fastEthernet 1/0/1-3
Switch(config-if-range)#ipv6 verify source sipv6+mac
Switch(config-if-range)#end
Switch#copy running-config startup-config
Verify the Configuration
Verify the binding entry:
Switch#show ip source binding
U
Host
-
----
1
legal-host
Notice:
1.Here, 'ND-D' for 'ND-Detection',and'IP-V-S' for 'IP-Verify-Source'.
Verify the configuration of IPv6 Source Guard:
Switch#show ipv6 verify source
Port
Fa1/0/1
Fa1/0/2
Fa1/0/3
......
IP-Addr
-------
2001::5
Security-Type
LAG
SIP+MAC
N/A
SIP+MAC
N/A
SIP+MAC
N/A
MAC-Addr
--------
74:d3:45:32:b6:8d
Configuration Examples
VID Port
ACL
---
----
---
1
Fa1/0/1 IP-V-S
Configuration Guide
SOURCE
------
Manual
678
Advertisement
Table of Contents
