Rip Summary-Address - H3C S6550X-HI Series Command Reference Manual

undo rip split-horizon
Default
The split horizon feature is enabled.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
The split horizon feature prevents routing loops. If you want to disable the feature, make sure the
operation is necessary.
On NBMA networks, such as FR where multiple VCs are configured on the primary and secondary
interfaces, disable split horizon to ensure correct route advertisement. For more information about
FR, see Layer 2—WAN Configuration Guide.
If both split horizon and poison reverse are enabled, only the poison reverse feature takes effect.
Examples
# Enable the split horizon feature on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip split-horizon

rip summary-address

Use
rip summary-address
Use
undo rip summary-address
Syntax
rip summary-address ip-address { mask-length | mask }
undo rip summary-address ip-address { mask-length | mask }
Default
No summary route is configured on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ip-address
mask-length
: Specifies the subnet mask of the summary route, in dotted decimal notation.
mask
Usage guidelines
This command takes effect only when automatic route summarization is disabled.
Examples
# Configure a summary route on VLAN-interface 10.
to configure a summary route on an interface.
: Specifies the destination IP address of the summary route.
: Specifies the subnet mask length of the summary route, in the range of 0 to 32.
to remove a summary route on an interface.
36