Preference - H3C S6550X-HI Series Command Reference Manual

Usage guidelines
Do not use the
the neighbor might receive both unicast and multicast (or broadcast) messages with the same
routing information.
This command must be executed together with the
command, which disables source IP address check on inbound RIP routing updates.
Examples
# Configure RIP to unicast updates to peer 202.38.165.1.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] peer 202.38.165.1
Related commands
validate-source-address

preference

Use
preference
Use
undo preference
Syntax
preference { preference | route-policy route-policy-name } *
undo preference
Default
The preference of RIP routes is 100.
Views
RIP view
Predefined user roles
network-admin
Parameters
preference
the higher the preference.
route-policy route-policy-name
string of 1 to 63 characters.
Usage guidelines
You can specify a routing policy by using the keyword
matching RIP routes.
•
The preference set by the routing policy applies to all matching RIP routes. The preference of
other routes is set by the
•
If no preference is set by the routing policy, the preference of all RIP routes is set by the
preference
Examples
# Set a preference of 120 for RIP routes.
<Sysname> system-view
[Sysname] rip 1
peer ip-address
to specify a preference for RIP routes.
to restore the default.
: Specifies a preference for RIP routes, in the range of 1 to 255. The smaller the value,
preference
command.
command when the neighbor is directly connected. Otherwise,
: Specifies a routing policy by its name, a case-sensitive
route-policy
command.
23
undo validate-source-address
to set a preference for