Table of Contents
Advertisement
Log in to the Oracle ILOM web interface using an Administrator account.
1.
Refer to
In the left pane, click Host Management → Power Control, and click Immediate Power Off
2.
in the Select Action list.
Click Save, and then click OK.
3.
The server powers down immediately to Standby power mode.
Disconnect the power and data cables from the server.
4.
See
Power Down the Server for Immediate Shutdown Using the On/Standby Button
Caution:
An immediate power-off might corrupt system data, therefore, use this procedure to
power down the server only after attempting the graceful power down procedure.
Press and hold the On/Standby button for four seconds to force the Main power off and to
1.
enter Standby power mode.
When the Main power is off, the System OK LED on the front panel begins blinking,
indicating that the server is in Standby power mode.
Disconnect the power cords and data cables from the server.
2.
See
Oracle ILOM
Documentation.
Disconnect Cables From the
Caution:
When you power down the server using Oracle ILOM, the server enters
Standby power mode. Power is still directed to the service processor and power
supply fans. To completely power off the server, you must disconnect the power
cords from the power supplies.
Disconnect Cables From the
Caution:
When you power down the server using the On/Standby button, the server
enters Standby power mode. Power is still directed to the service processor and
power supply fans. To completely power off the server, you must disconnect the
power cords from the power supplies.
Preparing the Server for Component Replacement
Server.
Server.
Chapter 2
2-11
Advertisement
Table of Contents
