Power On And Configure The System; Perform Initial Configuration - Oracle ZS9-2 Getting Started Manual

Hide thumbs Also See for ZS9-2:

Attaching a SAS cable in the wrong orientation at the controller HBA or the disk shelf I/O Module

Caution -

damages the port connector, and the system will not function properly.

The following procedure connects an AOC cable to the controller and to an Oracle Storage Drive Enclosure DE3-

24P disk shelf. For additional information, see Oracle ZFS Storage Appliance Cabling Guide available from

//docs.oracle.com/en/storage.

1. Facing the controller HBA, position the cable's release tab to the right (left panel) for the controller end, and to

the top for the disk shelf end (#1 in right panel).

2. Insert the cable connectors into the appropriate ports, aligning the cable connector latches (#2 in right panel)

with the port latch receiver holes (#3 in right panel). Ensure the latches engage with the receiver holes.

Power On and Configure the System

Required information: Network host name and port of your serial connection, or network management port DHCP-

assigned address. Connect disk shelf power cables, power on disk shelves, connect controller power cables, power

on controllers, and configure the system as described in the Oracle ZFS Storage Appliance Installation Guide

available from https://docs.oracle.com/en/storage.

For detailed information, see the Oracle ZFS Storage Appliance Installation Guide available from

oracle.com/en/storage, including properly configuring management interfaces and updating controller software.

https:

https://docs.

Table of Contents